![]() ![]() Every run perfect.Ģ) my euro sequencer actually missed a few starts when starting from the ERM on internal sync - I hadn’t noticed that happen before. They both looked perfect (including a slight delay of the first clock to be after the run signal starts). I have tried all of those things (except trying another DIN Sync receiving device as I don’t have any!).ġ) I used a DIN to audio splitter cable (ERM-made) and used it to trigger a VCA receiving an audio signal and recorded both the run and clock signals. You can get a adapter cable by E-rm from midi to cv start and reset. The best is with cv you don't have to set any latency, because there is none. I'm always using the Multiclock CV Out for Eurorack. Thanks!!Have you tried other Din sync devices? What sequencer are you using? Did you set the output to Din Sync? ![]() but clearly a different DIN Sync signal is coming out of the Multiclock when using the internal vs audio sync. The solution could very well be with the Euro sequencer but I’m not even sure what to tell them they would need to address. Always the same inconsistent start when using audio input sync on the Multiclock. And I’ve tried both the Din input into the Euro sequencer and using the Multiclock analog output into the run and clock jacks of the Euro sequencer. ![]() And I’ve done a factory reset of the Multiclock. I have also tried a few different outs from the Multiclock. The common denominator is I’m using a direct out from my MOTU 828ES interface, but again the Multiclock always starts. #Erm multiclock ableton shonky pro#the ERM plug in, bitwig’s HW clock device (with 1/96, 1ms, gate on), or just the sample and MIDI clip from ERM’s site, all in either bitwig or Logic Pro X. I’ve tried every different configuration I could. I do see a light engage on the Euro sequencer so perhaps it’s seeing the run signal but the clock is not advancing it. The Multiclock always starts when sync’d via audio input, but the Euro sequencer is hit or miss. But if I sync via audio input it is inconsistent. The odd thing is that if I use internal sync on the multiclock it works 100% of the time. I’m having an issue getting my Sequencer (eurorack module) to consistently start via Din Sync output from the Multiclock. I’ve reached out to ERM support a couple of times but never heard back so thought I’d give you all a shot. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |